[. . . ] 1 2 3 4 5 6 7 Lever Clamper Punch plate Abrasive paper Guide Velcro sandpaper Base 8 9 10 11 12 13 14 Plate Dust bag Hole Entry port Protrusion Dust spout Groove 15 16 17 18 19 20 21 Front fixing cardboard Front side of paper dust bag Claws Upper part Notch Guide Switch Model Pad size Orbits per minute Dimensions Net weight BO4553 116 mm × 104 mm 14, 000 120 × 112 × 137 (mm) 1. Due to our continuing program of research and development, the specifications herein are subject to change without notice. Intended use The tool is intended for the sanding of large surface of wood, plastics and metal materials as well as painted surfaces. [. . . ] Otherwise the paper will be loose and subject to slippage, resulting in uneven sanding operation. Place the punch plate over the paper so that the bent sides of the punch plate are flush with the paper edges. Be sure to align the holes on the sandpaper with the holes on the pad (the dust will be sucked into these holes; it is therefore important to leave them open). This tool has not been waterproofed, so do not use water on the workpiece surface. Ventilate your work area adequately when you perform sanding operations. Always use the correct dust mask/respirator for the material and application you are working with. CAUTION: Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. To maintain product SAFETY and RELIABILITY, repairs, carbon brush inspection and replacement, any other maintenance or adjustment should be performed by a Makita Authorized or Factory Service Centers, always using Makita replacement parts. Note: If the sandpaper is in good condition, save it for further use. The use of the dust bag makes sanding operations clean and dust collection easy. To attach the dust bag, fit the bag's entry port onto the dust spout on the tool so that the hole in the entry port is just over the protrusion on the dust spout. For the best results, empty the dust bag when it becomes about half full, tapping it lightly to remove as much dust as possible. To install the paper dust bag, place the paper dust bag on the paper dust bag holder with its front side upward. Insert the front fixing cardboard of the paper dust bag into the groove of the paper dust bag holder. [. . . ] ­ The typical weighted root mean square acceleration value is not more than 8 m/s2. ­ The typical weighted root mean square acceleration value is not more than 10 m/s2. EC-DECLARATION OF CONFORMITY We declare under our sole responsibility that this product is in compliance with the following standards or standardized documents, HD400, EN50144, EN55014, EN61000 in accordance with Council Directives, 73/23/EEC, 89/336/EEC and 98/37/EC. [. . . ]